Neo Traction Magnets for Tyco 440x2 Chassis - $3.99 pair These are available in either Level 42 or Level 52 Neo. Level 52 is only recommended for use in black, stiff chassis. The magnets are North / South oriented so they can be installed in either high downforce or low downforce (motor mode).
Neo Traction Magnets for Tomy Turbo Chassis - $3.99 each This magnet system is designed to be a drop-in replacement for Tomy Turbo ceramic magnet bars. They are made with Level 52 neo magnets and will give your Turbo performance similar to an SRT.
Neo Traction Magnets for Tomy Super G Plus and BSRT G3 & G3-R Chassis - $5.99 pair These are made with Level 42 neo magnets. The magnets are North / South oriented so they can be installed in either high downforce or low downforce (motor mode). It is recommended that you run a balanced armature and have a good quality track power supply and controller. Rear tire sizes and compositions will need to be considered when running these..
Neo Traction Magnets for Wizzard Storm Chassis - $4.99 Per Pair
Turn your Storm into an "EXTREME" with these Level 42 neo magnets. The magnets are North / South oriented so they can be installed in either high downforce or low downforce (motor mode).
It is recommend to use slip-on silicone tires or original standard factory Storm hard rubber tires when trying this modification. These magnets will create a lot of downforce so silicone sponge tires may bottom out. Not responsible for cooked armatures if you set your car up wrong.
Mega Neo Traction Magnets for Tomy SRT and MEGA-G! - $6.99 for 2 Pairs These magnets are virtually 'drop-in' for either a Tomy SRT or the newest Mega-G chassis. They can be installed oriented in either high or low downforce. In a Tomy SRT you can't tell be looking at the assembled car that you're running these critters. It'll make your car really unfair!!
The Mega-Gs have always needed more 'magnets' - so here they are. With the right size tires they give your Mega-G 40% more applied downforce. These will make your Mega-G actually fun to run. The bottom of the rear motor magnet clip in the long wheel-base chassis will have to be shaved off about .025" for best fit. The new shorter 1.5" wheel-base chassis has to have the 'keeper tap' on the inside of the magnet box just above the existing magnets shaved off. The replacement magnets are then glued into place - see the three above photos.
